Page: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

14.11.2006

Cold pressed parts for hospital equipment These drive shafts are produced, ready for installation, by means of cold forming pressing. The transmission parts in steel QSt 380 are used for segmental adjustments in... > continue

27.09.2006

USD construction site: structurally complete The annex is structurally complete, the walls have been set on the first and second floors. The scaffolding is in place, interior completion and setting of the window fronts... > continue

26.09.2006

Stainless steel escutcheons Produced in investment casting, this stainless steel escutcheon sets new standards in access control. The plates are used in access products for intrusion protection,... > continue

25.08.2006

USD construction site: 2nd floor Setting of wall elements and supporting pillars on the second floor by using a 100 ton crane with a 52 meter jib. > continue

14.08.2006

USD construction site: 1st floor The concrete elements of the first floor are being set. Front view of the corridor with staircase, door to one conference room on the right hand side. > continue

04.08.2006

USD makes you seat comfortably These sintered parts serve as a level adjustment for office chairs. Their smart teeth can be sintered directly within the given tolerances - expensive machining is avoided. > continue

26.07.2006

Re-launch of USD website Re-launch of USD website > continue

18.07.2006

Concrete pumps on site From the drum through the pump to our construction site, concrete and stone floor passes elbows and tubes made of manganese steel. USD produces these by casting. > continue

29.06.2006

The USD Foundation After laying the foundations for the supporting pillars and the elevator, they are filled with concrete. > continue

23.05.2006

Forged parts against burlary The swing bolts are produced by closed die forging and prevent doors equipped with those high tech locks from forced openings through burglary. > continue

Page: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16